Description The GLK12232-25-SM is capable of storing 128 font and bitmap ?les
up to 16 Kbytes total. In order to upload a bitmap to the
GLK12232-25-SM you must ?rst initiate the upload font ?le co
mmand
(0xFE 0x5E), you must then pass it a reference identi?cation
number,
which must be unique for every font on the display module. You
may
then pass the display module the two byte ?le system size, whi
ch needs
to be transfered LSB, then MSB. This is almost always the entire 16kB,
meaning the values 0x00 0x40 0x00 0x00 must be issued. The last part
of uploading a bitmap is transmitting the bitmap ?le data.
For detailed instructions on uploading a ?le to the GLK12232
-25-SM
see
Section 12 on page 43.
NOTE
This command is available but not not supported in I2C.
Remembered Always
7.3 Drawing a Bitmap from Memory
Syntax
Hexadecimal 0xFE 0x62 [refID] [X] [Y]
Decimal 254 98 [refID] [X] [Y]
ASCII 254 “b” [refID] [X] [Y]
Parameters
Parameter Length Description
refID 1 The bitmap identi?cation number.
X 1 Left bounds.
Y 1 Top bounds.
Description This command will draw a bitmap that is located in the on board
memory. The bitmap is referenced by the bitmaps reference
identi?cation number, which is established when the bitmap
is uploaded
to the display module. The bitmap will be drawn beginning at the top
left, from the speci?ed X,Y coordinates. A directory listin
g of the
contents of the entire ?lesystem may be obtained by using the
“Get
Filesystem Directory” command, see Section 12.5 on page 48 for more
detailed information.
Remembered No
7.4 Drawing a Bitmap Directly
Syntax
Hexadecimal 0xFE 0x64 [X] [Y] [W] [H] [D]
Decimal 254 100 [X] [Y] [W] [H] [D]
ASCII 254 “d” [X] [Y] [W] [H] [D]
Matrix Orbital GLK12232-25-SM
27